Here you will find frequently asked questions.
Approximately 10-15 minutes. The coating does not need to be dry.
24 hours. We always inspect the system 24 hours after coating, to ensure and document the quality. The system can be re-coated after 24 hours if more than one layer is needed.
215 µm (=120 µm dry film thickness). Total recommended consumption for optimal protection (VentGuard SC50): 400 g/m2 = 120 µm dry film thickness).
The smallest we can clean, and coat is 70mm. Standard sizes below. If you have specific measurements in mind, please let us know and we will find a solution that fits your need.
The following is our standard sizes:
1. Round, standard sizes: R80 mm, R100 mm, R125 mm, R160 mm, R200 mm, R250mm, R315 mm
2. Square, standard sizes: 80 x 80 mm, 100 x 100 mm, 150 x 150 mm, 100 x 150 mm, 200 x 200 mm
Concrete, plastic, stainless steel, and galvanized/ungalvanized are the most common material for us to work on. But the coating can be used on any surface, if it is not too porous. To ensure adhesion surfaces should always be clean and free of dirt, dust, rust etc. prior to coating.
We at Coatable delivers Environmentally friendly cleaning and coating solutions for increasing energy efficiency, lifetime and fire safety of the all kinds of ventilations ducts